Excess Chalking: Vancouver’s Best Painters
EXCESS CHALKING
by Rick Anderson Vancouver’s Best Painters
Chalking is the excess formulation of fine powder on the surface of a paint film.
Eventually, all paints chalk to some degree. Generally, alkyds chalk more quickly and to a greater degree than acrylic latex coatings. Chalking is a result of the breakdown of the coating binder because of its prolonged exposure to the ultraviolet rays of the sun.
Chalking is caused by failure to adequately prime and seal a porous surface, by over-thinning the paint prior to application, or by spreading the paint too thinly.
All oil paint will chalk to some degree as the result of exposure to sunlight. On most surfaces, especially white surfaces, moderate chalking is helpful because dirt is washed away with the chalk when it rains. In addition, chalking is a normal, desirable way for the paint film to wear away and provide a good surface for future repainting. However, a freely chalking type of paint should not be used above masonry or brick because the chalk wash down will leave an unattractive discoloration on these surfaces.
If you wipe your hand over a surface and the chalk dust covers your entire hand, you should think about repainting.
Sollution
The chalk residue must first be removed. This is easily accomplished with the use of a pressure washer. If one is not available, use a stiff brush and mild detergent and spray the chalky surface with a strong stream from a garden hose. The detergent will act as a lubricant to easily remove residual dirt and chalk in addition to any other foreign contaminants. After the surface has dried thoroughly, rub your finger to check if some chalk residue remains. If so, a surface conditioner (oil or acrylic) should be used under the finish coat.
If chalk wash-down on brick has occurred, the stains can be removed from the brick by scrubbing with a stiff brush and detergent solution. Use a strong stream from a garden hose to rinse. If the brick is a slightly different color after it dries, it can be masked by rubbing a piece of brick over the area, or by painting the area with a brick-colored coating.
Rick Anderson,
www.vancouversbestpainters.com
www.vancouverindustrialpainting.com
local: 604-PAINTER
Toll Free: 1-800-PRO-PAINTER
Posted in Painting Articles